Canon PIXMA MP960 Quick Start Manual page 43

W
Note
• If the film holder will not close properly,
reposition the film so that its perforations are
set properly in the film guide slots, and try
again.
• Make sure that all the protrusions on the outer
edges of the film holder fit into the slots in the
film guide when closing the film holder. If the
film holder does not close completely, press the
whole film holder gently downward.
Mounting a film strip that is shorter than the
film guide
When a film strip that is shorter than the film guide
is mounted, parts of the images around the blank
area may appear pale. In this case, set the Filler
Sheet for film strip (A) over the blank area to
shield it before scanning.
Setting the Filler Sheet for film strip
• Mounting a film strip in positions 1 to 4 of the
film guide:
Set the Filler Sheet for film strip (A) over the
blank area (positions 7 to 12) to shield it as
illustrated. You do not have to shield position 5
or 6, even though there is no film mounted in it.
• Mounting a film strip in positions 1 to 9 of the
film guide:
Set the Filler Sheet for film strip (A) over the
blank area (positions 10 to 12) to shield it as
illustrated.
Load the film guide on the Platen Glass as is,
even though the Filler Sheet sticks out of the
film guide.
(4) With the mark
fI
on the film guide facing up,
align the film guide "'lith the indentations on the
right and left sides of the Platen Glass.
(5) Confirm that the front side of the film (the side
showing the correct image) faces down.
(4)
(A)
(A)
W
Note
Labels attached to areas of the film without images may be interpreted as images and be included
in the scan.
Photo Printing from Photo or Film 39