Philips DVP3356 User Manual page 27

[ Digital Audio ]
Select the setting based on the digital
ampliÀ er/receiver that is connected
through the digital jack.
• [ Digital Output ]
digital output.
Option
[ Off ]
[ All ]
[ PCM Only ]
• [ LPCM Output ]
(Linear Pulse Code Modulation) output
sampling rate.
Option
[ 48kHz ]
[ 96kHz ]
Note
•
[ LPCM Output ]
[ Digital Output ] is set to [ PCM only ].
•
The higher the sampling rate, the better the sound
quality.
Downloaded From Disc-Player.com Philips Manuals
– select the type of
Description
Disable digital output.
The device supports
multi-channel audio
formats.
The device is not capable
of decoding multi-channel
audio. Audio is
downmixed to two-
channel sound: see
LPCM Output ]
setting.
– select the LPCM
Description
For discs recorded at
sampling rate of 48 kHz.
For discs recorded at the
sampling rate of 96 kHz.
setting is only available if the
[ Volume ]
Set the default volume level when you play
a disc.
1.
2.
3.
[ Sound Mode ]
Select a preset sound effect to enhance
the audio output.
•
•
•
[
[ Speaker Setup ]
When you connect a speaker system, you
can optimize surround output for the
connected speakers.
•
Option
[ Large ]
[ Small ]
Press OK.
b B to set the volume.
Press
Press OK to conÀ rm and exit.
[ 3D ] – select a virtual surround sound
effect that is produced from the left and
right audio channels.
[ Movie Mode ] – select a sound effect
for movies.
[ Music Mode ] – select a sound effect
for music.
[ Front Speaker ]
Description
Produce low frequency
signal below 120 Hz.
Cannot produce low
frequency signal below
120 Hz.
27