Adjusting Restraint System Straps - Boon FLAIR Instructions For Use Manual

ADJUSTING RESTRAINT SYSTEM STRAPS

SHOULDER STRAP HEIGHT ADJUSTMENT
Adjust shoulder strap height if necessary. Straps may need
to be adjusted based on the height of the child. The shoulder
straps are pre-assembled using the lower slots so that the
seat can initially be used for a smaller child. As your child
grows, these straps may need to be adjusted by moving
them to the higher slots. Follow the steps below to adjust the
shoulder straps. ALWAYS use the same height slots for both
sides of the shoulder straps.
1
STRAP REMOVAL
From the back of the seat, squeeze the strap tabs
together while pulling the strap from the front of the
seat. Repeat for the strap on the other side. If the seat
pad is in place, repeat this process to pull the shoulder
strap through the pad also.
3
STRAP CHECK
Inspect strap tabs and ensure tabs are flat against
back of seat. Pull straps on BOTH sides to ensure
that they are secure.
SHOULDER STRAP LENGTH ADJUSTMENT
Pull shoulder strap through slide adjuster to tighten or
loosen. Make sure that both shoulder straps are adjusted
to the same length.
2
STRAP INSERTION
Squeeze the strap tabs together and push through
opening. Repeat for the strap on the other side.
ALWAYS use the same height slots for both sides
of the shoulder straps.
Side Button
Slide adjuster
WAIST STRAP ADJUSTMENT
Slide strap through the exposed inside slot from the rear
to the front of the buckle. Squeeze the side button to
expose a second slot and insert strap from the front to
the rear through the outside slot. To tighten waist strap,
squeeze the side button and pull front strap outward,
as show above. To loosen waist strap, squeeze the side
button and pull rear strap outward.
5