Table of Contents
Advertisement
25.
Stay within air pressure capacity. Never operate the Nailer above 125 PSI.
26.
Hold tool away from head and body. During operation the Nailer may kick back
causing injury.
27.
Transport Nailer safely. Always disconnect air supply when moving the tool in the
workplace. Carry the tool by the handle to avoid contact with the trigger.
28.
Avoid working alone. If an accident happens, an assistant can bring help.
Note: Performance of the compressor (if powered by line voltage) may vary depending on
variations in local line voltage. Extension cord usage may also affect the tool
performance.
Warning: The warnings, cautions, and instructions discussed in this instruction
manual cannot cover all possible conditions and situations that may occur. It must
be understood by the operator that common sense and caution are factors which
cannot be built into this product, but must be supplied by the operator.
When unpacking, check to make sure all parts shown in the Parts List on page 13
are included. If any parts are missing or broken, please call Harbor Freight Tools at the
number on the cover of this manual as soon as possible.
For best service, you should incorporate an oiler, regulator, and inline filter, as shown
in the diagram below. Hoses, couplers, oilers, regulators, and filters are all available at
Harbor Freight Tools.
TO
ROOFING
NAILER
Note: To connect this tool, we recommend you use the included quick connector. For
smoother operation and to extend the life-span of the tool, put 3-5 drops of pneumatic
tool oil in the attached Air Inlet (61) before each use.
SKU 92918
For technical questions, please call 1-800-444-3353.
Unpacking
Operation
Rev 11/06
Page 5
Advertisement
Table of Contents
