Advertisement
Red light ON
Red light OFF
Charge complete
Charging
Li-po Battery
Using the supplied USB cable, plug the connector into the charging
port on the quad-copter, then plug the large USB plug into a USB wall
charger or a computer.
3.7V 100mAh
Turn the quad-copter power on, then place it down on a flat location. The
status indicator will flash. Do not move the device as the gyroscope is
calibrating.
Turn the remote control on, the push the throttle stick down to it's lowest
point, then push it up to the highest point. The remote control will send out
a signal and pair with the quad-copter
After use, please turn off the quad-copter to avoid depleting the batteries
further.
WARNING: If left paired and operating for too long, the battery may be
damaged due to over-discharge and may even become a fire hazard.
Turn off the remote control. If the remote control is not going to be used
for an extended period of time, please remove the batteries.
Input
Charging Current
5V
200 MAH
Approx 4 minutes
3
Full Voltage
4.2
Approx 30 minutes
Advertisement
