Page 1
Please read this guide carefully before use. To load the batteries: Open the battery cover on the back of the transmitter, then load 6 x AA batteries correctly as shown by the polarity markings. Make sure the battery polarities are •...
Page 2
In the event of misuse, the batteries may catch fire, leak or explode. The user • should be aware of the risks of using batteries. Kogan.com do not bear any responsibility for accidents that occur through misuse or accidents. If during use of during charging you notice smoke or a strange smell, unplug the •...
Page 3
1. The aircraft power cord and the battery cord should be connected as shown on page 1. Correct these together while the helicopter is sitting on flat ground. 2. After about 6 seconds, the LED lights will be flashing. To pair the controller and the helicopter, push the throttle stick to the bottom, then turn the power switch to ON.
Page 4
Note: once the copter ascends to a height of 30cm or above, it will suffer from the "ground effect" and the performance will become unstable. With practice you will be able to control this. When the copter continually spins to the left, please press the right trimming button until it stops spinning.
Page 5
If the copter is not easily controllable, this may require a full reset of the controller so that it can be recalibrated. Press both joysticks back and to the left, then press the throttle lever. The lights on the copter will flash, at which point you should release all of the controls.
Page 6
Transmitter is OFF Turn transmitter ON Reinstall batteries, paying attention to Transmitter not working Batteries not installed correctly the polarity markings Batteries are flat Replace batteries Transmitter is OFF Turn transmitter ON Copter battery is disconnected Reconnect the battery cables Control failure Do not fly the copter during extremely Wind is too strong...