Table of Contents
Advertisement
Status
Flash does not fire
Memory card is almost
or entirely full
The Reset Camera
feature did not take
effect.
Battery life is short
Shutter button does
not work.
Memory card not
recognized or camera
freezes with card
Pictures on card (or in
internal memory) are
corrupted
www.kodak.com/go/support
Solution
■
Check the flash setting, and change as needed
NOTE: The flash does not fire in all modes.
■
Transfer the pictures to the computer
■
Delete pictures from the card
■
After using the Reset Camera feature
camera off and then on again.
■
Make sure the correct battery type is installed
■
Charge the batteries
page
9).
■
Use a power-saving LCD Brightness setting
■
Turn on the camera
■
Transfer pictures to the computer
from the camera
memory
(see page
■
Card may be corrupted. Format the card in the camera
page
52).
Caution: Formatting a card deletes all pictures and
videos, including protected files.
■
Use another memory card. Only SD or SDHC Cards are supported.
■
Retake pictures.
■
Do not remove card while the camera is on.
■
Keep rechargeable batteries charged.
■
Transfer pictures to the computer
card or internal memory
Caution: Formatting a card deletes all pictures and
videos, including protected files.
(see page
(see page
1). Watch the battery level
(see page
3).
(see page
(see page
30), or insert a card with available
4).
(see page
(see page
52).
Troubleshooting
(see page
(see page
53).
30) or insert a new card.
(see page
51), turn the
(see page
65).
(see page
51).
53), delete pictures
(see
53), then format the
12).
(see
57
Advertisement
Table of Contents
