Important: Route the cables to the outside of the
handle knobs as you fold the handle.
Figure 27
1. Handle lock engaged
position
3. To unfold the handle, refer to 1 Unfolding the Handle
(page 5).
2. Handle lock disengaged
positions
Removing the Machine from
Storage
1. Return the machine and the handle to the operating
position.
2. Check and tighten all fasteners.
3. Remove the spark plug and spin the engine rapidly
using the starter to blow excess oil from the cylinder.
4. Install the spark plug and tighten it with a torque
wrench to 20 N-m (15 ft-lb).
5. Perform any needed maintenance procedures; refer to
Maintenance (page 13).
6. Check the engine-oil level; refer to Changing the
Engine Oil (page 14).
7. Fill the fuel tank with fresh gasoline; refer to Filling the
Fuel Tank (page 7).
8. Connect the wire to the spark plug.
17