Main Circuit Breaker - Pride Boxter Owner's Manual

I V .

Main Circuit Breaker

When the voltage in your Boxster’s batteries becomes low or your Scooter is heavily strained because of excessive
loads, the main circuit breaker may trip to protect your Boxster’s motor and electronics from damage.
When your Boxster’s main circuit breaker trips, the reset button pops out and your Boxster shuts down. (The
main circuit breaker reset button is mounted on the upper rear section of your Boxster, near the charger power
lead receptacle.) If the reset button pops out, perform the following steps.
1. Allow a minute or so for your Boxster’s electronics to “rest.”
2. Push in the reset button to reset the breaker.
Motor/Transaxle Assembly
The motor/transaxle assembly consists of a geared transmission and differential. This one-piece, direct drive, fully
sealed assembly provides quiet operation with maximum power and long life.
Charger Power Lead Receptacle
This receptacle enables you to plug the charger power lead into the Boxster. For further details on using the
charger power lead, refer to V. “Batteries and Charging.”
Electronic Controller Module
This module is located behind the batteries and at the forward left corner of your Boxster’s rear section. The
electronic controller module receives electrical signals from the console controls and sends power to the motor, the
brakes, and the lighting system.
WARNING! Do not expose the electronic controller module to moisture. If it does become exposed
to moisture, do not attempt to operate your Boxster until it has thoroughly dried.
Anti-tip Wheels
The anti-tip wheels are an integral and important safety feature of your Boxster which prevent your Scooter from
tipping rearward on an incline. They are located at the rearmost part of your Scooter.
WARNING! Do not remove your Scooter’s anti-tip wheels or modify your Scooter in any way
that is not authorised by Pride.
Boxster
Y O U R B O X S T E R
21