Advertisement
Analog inputs
Note: Shields should be connected at the signal source.
Analog Input wiring, current, 2 or 3-wire,
AN0 and AN1
24VDC
+ V
0 V
n/p
n/p
+V 0V
I6-7
I0-5
AN0 AN1 AN2 AN3
24VDC
Analog Input wiring, voltage,
AN2 and AN3
Note: If either I6 or I7 is wired as an npn digital input, the remaining input may not be wired as an
analog input.
24VDC
+ V
0 V
n/p
n/p
+V 0V
I6-7
I0-5
AN0 AN1 AN2 AN3
24VDC
The information in this document reflects products at the date of printing. Unitronics reserves the right, subject to all applicable laws, at any time, at its
sole discretion, and without notice, to discontinue or change the features, designs, materials and other specifications of its products, and to either
permanently or temporarily withdraw any of the forgoing from the market.
All information in this document is provided "as is" without warranty of any kind, either expressed or implied, including but not limited to any implied
warranties of merchantability, fitness for a particular purpose, or non-infringement. Unitronics assumes no responsibility for errors or omissions in the
information presented in this document. In no event shall Unitronics be liable for any special, incidental, indirect or consequential damages of any kind, or
any damages whatsoever arising out of or in connection with the use or performance of this information.
The tradenames, trademarks, logos and service marks presented in this document, including their design, are the property of Unitronics (1989) (R"G) Ltd. or other
third parties and you are not permitted to use them without the prior written consent of Unitronics or such third party as may own them..
4
3 wire
current
transmitter
+
+
2 wire
+
current
transmitter
I 7 I 6 I 5 I 4 I 3 I 2
I 1 I 0
+
+
I 7 I 6 I 5 I 4 I 3 I 2
I 1 I 0
Analog Input wiring, current, 4-wire,
AN0 and AN1
24VDC
+ V
0 V
n/p
n/p
+V 0V
I6-7
I0-5
AN0 AN1 AN2 AN3
24VDC
JZ10-11-T17
4 wire
current
transmitter
Power
Supply
+
I 7 I 6 I 5 I 4 I 3 I 2
I 1 I 0
DIG-JAZZ-T17 12/06
Unitronics
Advertisement
