The PDF version of this document can be found at the link below. https://www.leopardimaging.com/uploads/Leopard_USB_30_Camera_Kit_Quick_Start_Guide_M114.pdf The Leopard Imaging USB 3.0 Camera kit, bundled with Cypress EZ-USB FX3 CYUSB3KIT-001 Development Kit, enables the Cypress USB 3.0 platform to interface with the Leopard Imaging LI-CAM-M114 Camera Board. The kit includes the LI- USB30-ADAPTER board as well as the LI-CAM-M114 camera board.
Page 3
For J53, a jumper should be installed on the two pins close to SW9 (as shown below) No other jumpers need to be installed for this demo. For other jumper settings, please refer to the Cypress EZ-USB FX3 CYUSB3KIT-001 Development Kit documentation. Leopard Imaging Inc. 1130 Cadillac Ct Website: www.leopardimaging.com...
Page 4
On the hosting PC, open the Cypress “Control Center” (Start -> All Programs -> Cypress -> Cypress USBSuite -> Control Center) Note: The firmware image for the camera can be downloaded from https://www.leopardimaging.com/uploads/cyfxuvc_cypress_EVA_M114.img Leopard Imaging Inc. 1130 Cadillac Ct Website: www.leopardimaging.com...
Page 5
> “FX3” -> “RAM” and open the firmware image (cyfxuvc.img) g. When the program finishes, the kit will be identified by the PC as an USB camera. The Device name is FX3. The driver will automatically install, which may take some time. Leopard Imaging Inc. 1130 Cadillac Ct Website: www.leopardimaging.com...
Page 6
Open an application (such as Amcap) to view the live streaming. If you’re using Amcap, you may need to choose the FX3 device from the dropdown list. If you’re using GraphEdit, please create a graph as below and press play. Leopard Imaging Inc. 1130 Cadillac Ct Website: www.leopardimaging.com...
Need help?
Do you have a question about the LI-USB30-M114EVA and is the answer not in the manual?
Questions and answers