Advertisement
Quick Links
Advertisement
Related Manuals for Black & Decker Powerful Solutions SMS216
Summary of Contents for Black & Decker Powerful Solutions SMS216
- Page 1 Powerful Solutions SMS216 www.blackanddecker.co.uk...
- Page 2 English (Original instructions)
-
Page 7: Intended Use
Intended use If operating a power tool in a damp location is unavoidable, use a Residual Current Device (RCD) Your Black & Decker sliding compound mitre saw has been protected supply. Use of an RCD reduces the risk of designed for sawing wood, plastic and non-ferrous metal electric shock. - Page 8 d. Store idle power tools out of the reach of children Do not operate the machine without the guard in and do not allow persons unfamiliar with the power position. Do not operate the machine if the guard does tool or these instructions to operate the power tool.
- Page 9 The blade guard on your saw will automatically raise Risk of accidents caused by the uncovered parts of the when the arm is brought down; it will lower over the rotating saw blade. blade when the arm is raised. The guard can be raised Risk of injury when changing the blade.
- Page 10 Warning! The vibration emission value during actual use of Voltage drops the power tool can differ from the declared value depending In-rush currents cause short-time voltage drops. Under on the ways in which the tool is used. The vibration level may unfavourable power supply conditions, other equipment may increase above the level stated.
- Page 11 Assembly Tighten the two screws (33). Warning! Before assembly, make sure that the tool is Bench mounting (fig. H) switched off and unplugged. Note: We highly recommend that you bolt this mitre saw Note: This tool is accurately adjusted before shipping from securely to a work bench to gain the maximum stability of the factory.
- Page 12 Hold the main operating handle (2) and pull the carriage Tighten the high sliding fence clamp (43) to secure the (16) forward until the centre of the saw blade is over the fence in place. front of the work piece. Warning! The guide groove can become clogged with Operate the on/off switch (25) and press the saw arm sawdust.
- Page 13 Setting the cutting depth (fig. L) Settings Vertical position Horizontal position (back of moulding (Back of moulding The depth of cut can be preset for even and repetitive is against the is flat on the table) shallow cuts. fence) Adjust the cutting head down until the teeth of the blade ...
-
Page 14: Maintenance
changing the blades. Use correctly sharpened saw blades. Accessories Observe the maximum speed and tooth type marked on the The performance of your tool depends on the accessory saw blade. Only use Black & Decker recommended blades. used. Black & Decker and Piranha accessories are To replace the blade (24), proceed as follows: engineered to high quality standards and designed to Using a screwdriver, loosen but do not remove the... -
Page 15: Ec Declaration Of Conformity
Max capacity at 33.9° x 31.6° 45 mm x 254 mm technical file and makes this declaration on behalf of Black compound & Decker. Technical data SMS216 TYPE 1 Voltage Vac 230 Kevin Hewitt Power input W 1500 Vice-President Global Engineering... - Page 16 To claim on the guarantee, you will need to submit proof of purchase to the seller or an authorised repair agent. You can check the location of your nearest authorised repair agent by contacting your local Black & Decker office at the address indicated in this manual.
- Page 17 TYP. SMS216 103 115 39 31 www.2helpU.com 04 - 08 - 09 E15714...
- Page 19 ENGLISH Do not forget to register your product! www.blackanddecker.co.uk/productregistration Register your product online at www.blackanddecker.co.uk/productregistration or send your name, surname and product code to Black & Decker in your country.
- Page 20 90536929 Rev-1 L -10/09...