Integrated Peripherals - Gigabyte GA-78LMT-USB3 User Manual

& Password Check
Specifies whether a password is required every time the system boots, or only when you enter BIOS Setup.
After configuring this item, set the password(s) under the Set Supervisor/User Password item in the BIOS
Main Menu.
Setup
System
& HDD S.M.A.R.T. Capability
Enables or disables the S.M.A.R.T. (Self Monitoring and Reporting Technology) capability of your hard
drive. This feature allows your system to report read/write errors of the hard drive and to issue warnings
when a third party hardware monitor utility is installed. (Default: Disabled)
& Away Mode
Enables or disables Away Mode in Windows XP Media Center operating system. Away Mode allows the
system to silently perform unattended tasks while in a low-power mode that appears off. (Default: Disabled)
& Full Screen LOGO Show
Allows you to determine whether to display the GIGABYTE Logo at system startup. Disabled displays
normal POST message. (Default: Enabled)
& Init Display First
Specifies the first initiation of the monitor display from the installed PCI graphics card, PCI Express graphics
card, or the onboard graphics.
PCI Slot
OnChipVGA
PEG
2-5

Integrated Peripherals

OnChip SATA Controller
OnChip SATA Type
x OnChip SATA Port4/5 Type
x OnChip SATA Port as ESP
Onboard LAN Function
Onboard LAN Boot ROM
` SMART LAN
Onboard Audio Function
Onboard USB 3.0 Controller
USB Controllers
USB Legacy Function
USB Storage Function
Onboard Serial Port
Onboard Parallel Port
Parallel Port Mode
x ECP Mode Use DMA
: Move Enter: Select
F5: Previous Values
& OnChip SATA Controller
Enables or disables the integrated SATA controllers. (Default: Enabled)
& OnChip SATA Type (SATA2 0~SATA2 3 connectors)
Configures the operating mode of the integrated SATA controller.
Native IDE
RAID
AHCI
A password is only required for entering the BIOS Setup program. (Default)
A password is required for booting the system and for entering the BIOS Setup program.
Sets the PCI graphics card as the first display. (Default)
Sets the onboard graphics as the first display.
Sets the PCI Express graphics card on the PCIEX16 slot as the first display.
CMOS Setup Utility-Copyright (C) 1984-2012 Award Software
Integrated Peripherals
+/-/PU/PD: Value
F6: Fail-Safe Defaults
Allows the SATA controllers to operate in Native IDE mode. Enable Native IDE mode
if you wish to install operating systems that support Native mode. (Default)
Enables RAID for the SATA controller.
Configures the SATA controllers to AHCI mode. Advanced Host Controller Interface
(AHCI) is an interface specification that allows the storage driver to enable advanced
Serial ATA features such as Native Command Queuing and hot plug.
[Enabled]
[Native IDE]
IDE
Press Enter
[Enabled]
[Disabled]
[Press Enter]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[3F8/IRQ4]
[378/IRQ7]
[SPP]
3
F10: Save
- 25 -
Item Help
Menu Level `
ESC: Exit F1: General Help
F7: Optimized Defaults