Superior Fireplaces VRL4543ZMN Installation And Operation Instructions Manual page 12

Mantel Clearances for Built-In
Installation
If placing mantel above built-in fireplace, you
must meet minimum clearance between man-
tel shelf and top of fireplace opening.
NOTICE: If your installation does
not meet the minimum clear-
ances shown, you must do one
of the following:
• raise the mantel to an accept-
able height
• remove the mantel
NOTICE: Surface temperatures
of adjacent walls and mantels
become hot during operation.
Walls and mantels above the
firebox may become hot to the
touch. If installed properly,
these temperatures meet the
requirement of the national
product standard. Follow all
minimum clearances shown in
this manual.
ELECTRICAL WIRING
INSTRUCTIONS
1. Remove electrical cover plate with bush-
ing from left side of fireplace front by
removing 2 sheet metal screws as shown
in Figure 9.
2. Slide power source wiring through electri-
cal bushing opening and electrical cover
plate and make all necessary connec-
tions.
3. Slide all wiring connections in electrical
housing as shown in Figure 9.
4. Secure electrical cover plate with screws
previously removed.
Note: Electrical housing and cover plate have
sharp edges. Wear protective gloves.
12
INSTALLATION
Continued
www.SuperiorFireplaces.US.com
Electrical
Bushing
14GA
Black &
Electrical
White
Housing
Receptacle
(Supplied)
Ground
(16GA Green)
Figure 9 - Connecting Electricity
CHECK GAS TYPE
Use proper gas type for the fireplace unit you
are installing. If you have conflicting gas types,
do not install fireplace. See retailer where you
purchased the fireplace for proper fireplace
according to your gas type.
INSTALLING GAS PIPING TO
FIREPLACE LOCATION
WARNING: A qualified service
person must connect fireplace
to gas supply. Follow all local
codes.
CAUTION: Never connect pro-
pane/LP fireplace directly to the
propane/LP supply. This fireplace
requires an external regulator
(not supplied). Install the external
regulator between the fireplace
and propane/LP supply.
Sheet
Metal
Screws
Electrical
Cover
Plate
Wire Nut (3x)
(Not Supplied)
Power Source Wiring
(Not Supplied)
To Power
Source
Electrical Cover
Plate and
Electrical Bushing
Outer Wrapper
of Fireplace
126861-01A