Makita 6226DW Instruction Manual page 13

CAUTION:
*Pressing excessively on the
tool
will not speed up the drilling. In fact, this excessive pres-
sure will only serve to damage the tip of your bit, decrease the tool performance and
shorten the service life of the
tool.
@There is a tremendous force exerted on the tool/bit at the time of hole breakthrough.
Hold the tool firmly and exert care when the bit begins to break through the workpiece.
*A stuck bit can be removed simply by setting the reversing switch to reverse rotation in
order to back
out.
However, the tool may back out abruptly if you do not hold
it
firmly.
*Always secure small workpieces in a vise or similar hold-down device.
*If the tool is operated continuously until the battery cartridge has discharged, allow the
tool to rest for 15 minutes before proceeding with a fresh battery.
Installing set plate
For 62260 & 6227D
Always install the set plate when using bat-
tery cartridges 9100, 9102, 9102A for
6226D and 1200, 1202, 1202A for 6227D.
Install the set plate on the tool with the
screw provided.
13