Table of Contents
Advertisement
Configuring the Bluetooth Connection
In order to use the Focus 40 Blue with JAWS wirelessly over Bluetooth,
you must configure a Bluetooth partnership between the Focus and
computer and configure JAWS to use the Bluetooth COM port.
To set up a Bluetooth connection between the Focus display and JAWS,
do the following:
1.
Make sure that Bluetooth is enabled on the computer running
JAWS. If you are using an external USB Bluetooth adapter,
insert it and ensure it is detected properly.
2.
Power on the focus. The firmware version and battery status
information is displayed.
3.
On the computer, go to the Control Panel and select Bluetooth
Devices.
4.
When the Bluetooth Devices dialog box opens, press TAB to
move to the Add button and press ENTER.
5.
Use the SPACEBAR to check the My device is set up and ready
to be found check box then choose Next to begin searching for
Bluetooth devices. This may take several seconds. You are
placed in the list of devices when the search is complete.
6.
Use the ARROW keys to select Focus 40 BT from the list then
choose Next. If the Focus display was not found, make sure it is
turned on then select the Search Again button.
7.
Select the Use the passkey found in the documentation radio
button, press TAB to Move to the Passkey edit field, type 0000,
and choose Next.
16
Advertisement
Table of Contents
