Basic Operation; Turn On; Turn Off - NightWatcher HVR5006D-E User Manual

3.1 Turn on

Plug in the power adaptor and turn on the power supply. The power supply indicator light indicates the DVR
is on. After startup you will hear a beep. The default setting of video output to a monitor is multiple-window
output mode. If the startup time is within the video record settings time then the timing video recording function
will start up automatically. Then the video indicator light of the corresponding channel is active and the DVR is
working normally.
Note:1. Make sure that the input voltage corresponds with the switch of the DVR power supply.
2. Power supply demands: 220V±10% /50Hz-60Hz.
We recommend using a UPS to protect the power supply under certain conditions.

3.2 Turn off

There are two methods to turn off the DVR; Soft-switching：Entering [right menu] and choosing [turn off] in
the [turn off the system] option; Hard-switching：Disconnect mains lead.
Note:
1、Auto resume after power failure
If the DVR is shut down abnormally, it can automatically backup video and resume previous working
status after a power failure.
2、Replacing the hard disk
Before replacing the hard disk, the power supply must be turned off.
3、Replacing the battery
Before replacing the battery, the settings information should be saved and then the power supply should
be switched off. The DVR uses a button battery. The system time should be checked regularly. If the time is
not correct you should replace the battery, we recommend replacing the battery every year and using the same
battery type.
Note: The setting information must be saved before replacing the battery otherwise information will be lost.

3. Basic operation

16
NightWatcher D1 Digital Video Recorder User Manual