Porsche 911 GT3 Owner's Manual page 154

A - Diagnostic socket
Replacing fuses
In order to prevent damage to cables and consum-
ers in the electrical system due to short circuits
and overloads, the individual circuits are protect-
ed by fuses.
The fuse box is at lower left in the driver's footwell
and is protected with a plastic cover.
A - Plastic gripper
B - Spare fuses
1. Before replacing a fuse, switch off all electrical
consumers and remove the ignition key.
2. To open, pull the cover off at the finger hole
(arrow).
The fuse plan and instructions for emer-
gency unlocking of the luggage compart-
ment lid and engine compartment lid can
be found on the inside of the cover.
3. To check or replace a fuse, remove it from the
spring clip using the plastic gripper A.
A blown fuse indicates an overload in the cir-
cuit and can be identified by the melted metal
strip.
4. Replace only with fuses of the same rating.
Spare fuses B are in the lowest section of the
fuse box.
Important note
~ If a fuse blows repeatedly, please immediately
consult an authorized Porsche dealer, so that
the short circuit can be located and corrected.
~ Never try to "repair" fuses: you may cause se-
rious damage to other parts of the electrical
system.
Practical Tips, Emergency Service
~ ~ ~