Gas Pressure Regulator - Miele KM 320 Installation Instructions Manual

Gas pressure regulator

A pressure regulator that is convertible
from natural to LP gas (Propane) or vice
versa is included with the appliance.
The included regulator corresponds
with the gas type of the cooktop. Verify
before installing.
The adjusted pressure is:
natural gas - 4" w.c.
LP gas - 10" w.c.
A straight thread adapter, from ½" ISO
7-1 to ½" NPT is connected to your gas
pressure regulator. If an elbow adapter
is necessary for your particular
installation, a customized one can be
obtained free of charge from the Miele
Technical Service Department.
Do not use a standard elbow, it may
cause a gas leak.
As shown in the diagram, the included
regulator and adapter must be used
when connecting the Miele cooktop to
your gas supply. These items has been
customized by Miele to meet all
applicable safety requirements. Make
sure the regulator is easily accessible
for adjustment after the appliance has
been installed.
For convenience, an AGA or CGA
approved flexible stainless steel gas
hose (accordion type) may be used
between the gas connection and the
regulator. This will allow the appliance
to be lifted out of the countertop for
cleaning or servicing. Make sure that
any drawers, cabinet doors, etc., do not
rub on this gas hose.
Do not use any regulator/adapter
unless it has been supplied by
Miele. Doing so may cause a gas
leak.
If there is any doubt concerning
installation contact the Miele Technical
Service Department:
U 1-800-999-1360
techserv@mieleusa.com
V 1-800-565-6435
service@miele.ca
After connecting the appliance check
all fittings for gas leaks e.g. with
soapy water.
When installed properly, the flame will
be steady and quiet. It will also have a
sharp, blue inner core that will vary in
length proportional to the burner size.
Flame adjustment will not be necessary.
Gas connection
11