Parts Identifi Cation - A.O. Smith POWER VENT GAS Installation And Operating Manual

PARTS IDENTIFICATION
ITEM #
A Baffl e, Flue
B Hot Water Outlet Nipple (w/ Anode, Heat Trap)
C T&P Relief Valve
D Cold Water Inlet Nipple (w/ Dip Tube, Heat Trap)
E Cover, Back-Flue Gas Return
F Top Insulation
G Flue Gas Return Duct Assy
H Shroud, Back-Tank Assembly
I Shroud, Right Side-Tank Assembly
J Temperature Switch
K Condensate Trap
L Baffl e, Exhaust
M Hose, 12" Braided (Heat Engine Cold In)
N Drain Valve
O Tank Thermistor (Probe)
P Front Door Lock (Hook Cam)
Q Shroud, Right Side-Tank Assembly & Door
R Display Subassembly
S Heat Engine
T Cover, Front-Flue Gas Return
U Hi-Limit Temperature Switch
V Air Inlet Cover (Direct Vent)
W Air Inlet Cover Gasket (Direct Vent)
X ECO Switch
Y Transformer
Z Circuit Board Assembly (w/ Base)
1 Power Cord Assembly
2 Flame Sensor
3 Spark Generator
4 Gas Valve
5 Blower Motor Assembly
6 Circulation Pump
7 Internal Flow Valve
8 Front Cover Gasket
9 Water Inlet Fitting (Flange)
10 Inlet Water Filter
11 Return Fitting (Flange)
12 Barbed Fitting
13 Heat Exchanger
48
DESCRIPTION
www.hotwater.com 316888-001 Rev. 00 dRaFt Jun 28 245