Tenda P200 User Manual page 37

P200 200Mbps PowerLine Mini Adapter
How to add more adapters to the encrypted private network
Now that Adapter 1 and Adapter 2 created a network, say N1, and
you're trying to add Adapter 3 to this network, do as follows:
1. Press the Pair button on Adapter 3 for 2-3 seconds and then release it. If
the Power LED on the Adapter 3 starts blinking, it indicates adapter 3 is
searching for available network.
2. Within 2 minutes upon releasing adapter 3's Pair button, press the Pair
button on either Adapter 2 or Adapter 1 for 2-3 seconds and then release it.
The Power LED on the Adapter 3 will start blinking, indicating that such
adapters are interconnecting.
3. Observe adapter 3's LED status. If both Power and PLC LEDs deliver solid
lights, it indicates Adapter 3 has been successfully connected to Network 1.
To disconnect an adapter from the existing Powerline network, do as
follows:
33