Control Panel Block And Resistor Assembly (Focus Pack) Removal; Beznet Block Removal; Chassis Block Removal - Sony KP-48PS2 Service Manual

2-4. CONTROL PANEL BLOCK AND
RESISTOR ASSEMBLY
(FOCUS PACK) REMOVAL
5 Control panel
block
4 Two screws
(Hexagon head)
3 Front board
1 Speaker
grille
assembly

2-5. BEZNET BLOCK REMOVAL

5 Beznet block
4 Four screws
(Hexagon head)
2 Nine screws
7 Resistor
(Hexagon head)
assembly
(Focus pack)
6 Screw
(+BVTP 4 x 16)
1 Ten screws (KP-48)
Thirteen screws (KP-61)
(+BVTP 4 x 16)
3 Mirror cover
block
2 Four screws (KP-48)
Six screws (KP-61)
(Hexagon head)

2-6. CHASSIS BLOCK REMOVAL

(1) MAIN BRACKET REMOVAL
Set the main
3
bracket.
Pull the main bracket, and
2
remove each connectors
on main bracket.
Pay particular attention to the wires of each Printed circuit
boards when puling out the main bracket.
(2) CHASSIS BLOCK REMOVAL
Two screws
1
(Hexagon head)
Pull out the chassis block by gripping the handles as shown in
the diagram.
At this time, pay particular attention to the components
removed in (1).
– 9 –
KP-48PS2/61PS2
K
RM-903
Two screws
1
(Hexagon head)
Four screws
1
(Hexagon head)
Pull out the
2
chassis block.