Filling The Water Tank - Air innovations Clean Mist Smart Humidifier Instruction Manual

Filling The Water Tank

CAUTION:
Always unplug the unit before removing the Water Tank. Do not touch the water in the base.
NOTE:
Never fill the water tank from the top of the unit. Follow Water Tank filling instructions in #4.
1
Remove Extension Nozzle and
Dual Directional Mist Nozzle
prior to filling the water tank.
2
Lift the handle on top of the
Water to remove the Humidifier
from the base.
3
Make sure the handle is
snapped back into place, then
turn the Water Tank upside
down and remove the Tank Cap
by turning it counter clockwise.
4
Fill the Water Tank with clean,
cool tap water. Do not use
extremely cold water, since it
may temporarily reduce the
mist output. Never fill with
hot/warm water or add ad-
ditives as this could damage
the unit and void the warranty.
4
5
6
7
8
Attach Ceramic filter
(included) to the Tank
Cap by aligning the lock
tabs on both and turning
the cap counterclockwise
to lock. When attached
properly the Filter will not
fall from the Tank Cap.
Replace the Tank Cap by
firmly turning clockwise until
tight. Turn the Water Tank
upright and check the Tank
Cap for leaks. If any water
drips, remove the Tank
Cap and retighten. Do not
place Water Tank on the
Humidifier Base if the cap
is leaking.
Lift the handle up and replace
on the Humidifier Base, make
sure to follow the shape of the
Water Tank and the Humidifier
Base (as shown to the left) so
that the tank sits level and flush
to the base. Ensure the tank is
firmly seated.
Attach the Dual Directional
Mist Nozzle or Extension
Nozzle & Dual Directional Mist
Nozzle together to the top of
the Humidifier Tank for desired
use as pictured.