COMPRO VideoMate S700 User Manual page 17

Step 4:
For LNB/Transponders settings, you will see settings for satellites and transponders.
(1). Find and click on required satellite on list. Fill appropriate LOF1, LOF2, SW values.
Please read instruction of LNB convertor you use. Don't forget to click on "Apply"
button when you finish setup satellite LNB parameters.
(2.) Click on button "Sel All" (right side of window) to select all transponders or while
holding "Ctrl" key click sequentially on every transponder you want to scan. Click on
button "-=SCAN=-" to start scanning process.
Note:
If you see universal (dual-band) Ku LNBF then usual parameters are:
LOF1=10600000, LOF2=9750000, SW=11700000. If you use DiSEqC switch
or motor then click on DiSEqC button and choose appropriate LNB input port.
16