Fit; Saddle Position - ezee Sprint 2008 User Manual

3.1.5 Installing handlebar / stem / threadless headset
The handlebar and stem comes pre-assemble. Remove packaging material, loosen all 3 bolts
on the stem, turn the handle bar assembly so that it is perpendicular to the frame.
Tightening the stem bolt located at the top with hex key, then tighten the 2 side bolts. Wrong or
reversed procedure will not enable the fork to be securely seated on the crown / bearings.
3.1.6 Installing the pedals
There are 2 pedals, each of them are marked with either "R" or "L" indicating right and left
pedals respectively. Screw in clockwise for the right pedal and counter-clockwise for the left,
then tighten both with a wrench. The thread in the crank is made of Al Ally and could be easily
damaged during riding if the pedals are not tightened.
3.1.7 Front mudguard
The supports are attached to the sides and the top of the front fork, ensure all nuts and bolts
are fastened. The mudguards are made from high quality polycarbonates and should not rattle
when securely fastened.
3.1.8 Brakes
Brakes are one of the most important safety features on the bicycle. Please ensure that the
brakes on your bicycle are always set right in order to minimize your risk being injured. Tighten
brakes and ensure that the V-Brake pads are parallel to the rim and that the distance between
rim and brake pad should not exceed by more than 2mm. Test by squeezing brakes and check
for firmness. You may continue to fine tune with a Philips screwdriver. If you are unsure, we
recommend that you visit your local professional bike mechanic to help you. The front brake is
a rim brake / V-brake and the rear brake is a Shimano Roller brake. Ensure brakes are firm an
working well. Please refer to the attached Shimano manual.
3.1.9 Accessories
Install any accessories options that you have purchased together or is all ready provided with
your package.

3.2 Fit

Make sure the bike fits you. Every bike rides differently, so try out your bike at a location with little
traffic to adjust it till you find yourself comfortable and confident on the bike.
Standover height.
It is the distance from the ground to the top of the top tube at the point where your crotch would be if
you were straddling the bike by standing half way between the saddle and the handlebar stem. To
check, straddle the bike. If your crotch touches the frame, the bike is too big for you. A bike you ride
only on-road should offer a minimum clearance between top tube and your crotch of 2.5 to 5 cm (one
to two inches).

3.2 Saddle position

Correct saddle adjustment is important in getting the best performance and comfort from your bicycle.
a. Up and down adjustment
8