Tail Lights; Side Turn Signal Lights; Centre High-Mounted Brake Light - Opel Vivaro Owner's Manual

Tail lights

Rear brake, turn signal and tail
lights
1. Remove the 3 screws (using the
tool supplied).
2. Carefully pull lamp assembly from
retaining pins on the outer side
and remove.
3. Rotate bulb holder anticlockwise
to separate from lamp assembly.
4. Renew bulb.
5. Push to install the bulb holder into
the lamp assembly, then rotate
clockwise to secure.
6. Check that the wiring harness is
located correctly.
7. Replace lamp assembly into
original position, ensuring that it is
seated correctly.
8. Fit lamp assembly onto retaining
pins and replace the 3 screws.
Vehicle care

Side turn signal lights

1. Release clips from fender using a
flat blade screwdriver and lift out
lamp assembly from aperture.
2. Remove bulb holder from lamp
assembly by rotating
anticlockwise and renew bulb.
3. Install bulb holder in lamp
assembly and install lamp
assembly into aperture.
Centre high-mounted
brake light
1. Open the rear doors/tailgate.
149