Air Inlet Connection; Air Outlet Connection; Fixed Protections; Diffusion Plenum - Desa BI 60 Technical Information, Assembling Instructions, Use And Maintenance

Bi series vertical warm air heaters

Table of Contents

Connect any eventual channelling to the hot air distribution circuit to the equipment upper delivery flange, interposing a

vibration damper joint to prevent vibrations being transmitted to the pipes.

WARNING!

The dimensioning of eventual air inlet and outlet channels has to be previewed by qualified personnel in

compliance with the maximal performances of the heater as indicated in the "TECHNICAL DATA".

Connect any channelling in the air recovery circuit to the side opening. The equipment is made to take the connection on

the left and on the right side. To adapt the air intake side it is enough to invert the mounting of the side closing panel/s

with the intake grid/s.

To prevent accidental contact with the moving parts of the heater, it is not allowed to remove the equipment permanent

guards and protections, which consist of the following:



Air recovery grid/s;



Side closing panel/s;



Burner guard.

If the heater is to be installed inside the room to be heated, it is necessary to use a diffusion plenum which is supplied as

All Parts available from

an accessory. To obtain optimal air diffusion it is recommended that the equipment gets installed close to a perimeter

wall, or at the centre of the room itself, with the air delivery on three or four sides respectively.

www.sparesgiant.com

01772 329 565

DIMENSIONAL FEATURES

Type