Samsung HT-D350K User Manual page 13

Installing the Speakers on the Half Tallboy Stand
* HT-D353HK only - Front Speakers
1. Stretch out the speaker cable and arrange it through
the hole of the stand base as shown.
2. Tighten the stand nut (C) as shown and use the stand
screwdriver (D) to tighten it in the arrow direction.
3. This is after the speaker is installed completely.
Tighten the other speakers in the same manner.
Installing the Speakers on the Tallboy Stand Installing the Speakers on the Tallboy Stand
* HT-D355K only - Front/Surround Speakers
1.
Turn the Stand Base upside-down and connect it to
the Stand.
2. Insert small screws (4*20, For connecting Stand & Stand
Base) clockwise into the four holes marked using a
screwdriver as shown in the illustration.
!
CAUTION : When you use a torque screwdriver, be
careful not to put excessive force. Otherwise, it runs
idle or can be damaged. (torque screwdriver- below 15
kg.f.cm)
3. Connect the upper Speaker to the assembled Stand.
4. Insert another large screw (5*15, For connecting Speaker
& Stand) clockwise into the hole on the rear of the
speaker using a screwdriver.
5. This is the appearance after the speaker is installed.
Follow this steps to install other speaker.
Adjusting the height of the Half Tallboy Speaker
* HT-D353HK only - Front Speakers
1. If you want to change the speaker position (height),
remove two screws in the rear side.
2. Pull up the speaker in the arrow direction as shown.
(See fi gure 2)
!
CAUTION : Do not apply excessive force. Otherwise, it
may cause a physical injury.
Downloaded From TheatreSystem-Manual.com Manuals
1
2
3
1 2
Stand
Base
Stand
3 4 4
Speaker
Stand
5 5
1 2
English
1 1