Page 1
GARMENT STEAM IRON MODEL: EGSI-C1540(OR) Owner’s Manual Please read this manual carefully before operating your set. Retain it for future reference. Record model number and serial number of the set. See the label attached on the set and quote this information to your dealer when you require service.
Return the appliance to the nearest authorized service center for examination, repair or adjustment. 7. The use of foreign accessory attachments that are not supplied by ELBA is not recommended as it may result in fire, electric shock or personal injury.
PRODUCT DESCRIPTION (A) Steam head holder 10. Water reservoir (B) Cloth hanger hook Steam head 11. Rolling casters Handle 12. Folding rack Telescopic pole 13. Clips Hose 14. Holding nips Pole base 15. Drainage valve Hose base 16. Fabric brush Switch 17.
Page 4
ASSEMBLY INSTRUCTIONS 1. Loosen the clips on the telescopic pole. Pull the whole pole to its full extension and tighten the clips. Put the cloth hanger hook onto the top of the telescopic pole as shown in figure 2. 2. Insert the bottom of the telescopic pole into the pole base then turn the pole base lock clockwise until tightened and insert the hose onto the hose base by turning the fitting on the end of the hose clockwise as shown in figure 3.
Page 5
FOLDING RACK ASSEMBLY 1. Insert the cloth hanger hook (A) into the telescopic pole (B) shown in figure 6. 2. Insert the folding rack (C) into the hole at the cloth hanger hook (A) about tilting 40 degree (C) in figure 7. 3.
OPERATING THE APPLIANCE 1. Unplug the power cord, and turn the switch to the “OFF” position. 2. Remove the water tank, turn it upside down, and unfasten the water tank valve cap (see figure 15). Fill the water tank with cool water, and fasten the valve cap. Do not use hot water! 3.
HOW TO USE THE DRAINAGE VALVE 1. Unscrew the drainage valve which is at the back of the appliance anticlockwise. Refer to figure 19. 2. Empty the water reservoir after finished steaming, when the appliance is not in use or before storage.
REMOVING MINERAL BUILD-UP It is common for minerals found in hard water to build up inside the appliance, causing intermittent or weak steam. If you do not use de-mineralized or distilled water in your steamer, follow these steps monthly: 1. Turn the unit off, and unplug the power cord. 2.