Troubleshooting - Amplicomms TV 2410NL Wiring & Installation Manual

O
PERATION

Troubleshooting

No sound
- Ensure that the mains adapter is pushed fully into the power outlet and
that its cable is properly connected to the DC IN connector on the trans-
mitter.
- Ensure that the receiver power ON/OFF switch is switched to ON.
- The charge level of the battery inside receiver may be too low. Recharge
the battery or replace it with a fully charged battery.
- Ensure that the TV set, Hi-Fi system or audio component is switched ON
and set to a channel that broadcasts an audio signal.
- Use the volume control on the receiver to increase the sound level.
- The connected audio/video equipment may not be in playback mode.
Start playback on by the equipment.
- The receiver output level is set too low. Adjust the volume to a suitable
level.
- Try using a different connection RCA, SCART or HEADPHONE or use the
supplied microphone.
Distortion
- The charge level of the battery inside the receiver may be too low. Rechar-
ge the battery or replace them with a fully charged battery.
- The receiver may be too far away from the transmitter. Move closer to it.
- The audio signal input level is too low. Increase the volume from the
audio source.
- The audio signal input level may be too high, lower the volume from the
audio source.
10
Helpline UK 0844 800 6503
(See page 14 for costs and hours of operation)