Cocoon HE414114 Getting Started Manual

DOOR INTERCOM SYSTEM
WITH 2.4" COLOUR LCD

Getting Started Guide

1.

UNPACK

Unpack the Cocoon Door Intercom with 2.4" Colour LCD from the packaging and check you have all the components:
• 1 x Exterior Doorbell with Camera and Microphone
• 1 x Internal Handset with Monitor
• 1 x Mounting Bracket for Exterior Doorbell
• 1 x AC Adapter
2.

CONNECT

Note: Please ensure your handset is not connected to power when connecting wires.
1. Connect the handset to the monitor base unit using the port on the bottom of the base unit.
2. Slightly loosen each screw for the connection points in the back of the handset base using a Philips head
screwdriver (not supplied).
3. Insert each prong of your 10 metre cable under the screw at the back of the handset base, ensuring the colour
of each connection matches its corresponding connection point (Refer to image below).
4. Tighten each screw so your connection is firm and will not come loose during everyday use.
5. Connect your AC adapter to your handset by plugging it into the back of the handset base.
Note: Prior to installation, please ensure you test your product by connecting the doorbell to the Handset via the 4 pin
connector cable
After Sales Support 1300 663 907
www.winplus.com.au
TO CAMERA
TO AC ADAPTOR
• 1 x 10 metre cable
• 1 x Doorbell Seal
• 1 x Doorbell Mounting Kit (includes 4 screws, 4 screw
plugs and 4 screw covers)