Panasonic Workio DP-C262 Operating Instructions Manual page 11

Handling
■ Control Panel
Do not lift or lean against the Control Panel. The Control
Panel can be broken which could result in injury.
■ Power Switch
●
Used to turn ON or OFF the Main Power Switch on
the Rear Side of the machine, and to turn ON or OFF
the Power Switch on the Left Side of the machine.
Follow this procedure when turning OFF the Main
Power of the machine:
- Turn OFF the Power Switch on the Left Side of the
machine, wait a few seconds, and then turn OFF
the Main Power Switch on the Rear Side of the
machine.
●
If you are not going to use the machine for long periods
of time, turn OFF the machine using the procedure
above.
●
Do not turn off the Power Switch on the Left Side of
the machine or open the Front Cover during copying/
printing.
Main Power
Switch (Rear
Side)
ON ( )
OFF ( )
■ Auto Reset Time
The initial setting for Auto Reset Time is 1 minute.
If you do not touch any key for 1 minute, the touch panel
display will be back to the initial screen of the active
function automatically. 20 seconds before resetting, the
"Continue" screen is displayed to extend the auto reset
time for another 1 minute.
If you wish to change Auto Reset Time, consult with your
Key Operator.
■ Dept. (Department) Code
When the Department Counter function is set up, the
Dept. (Department) Code input screen is displayed on
the Touch Panel Display. A registered Department Code
(1 to 8 digits) is required to gain access to each secured
function, or the secured Copy/Scanner function(s) cannot
be used. Please consult with the Key Operator regarding
the Department Code(s) for the desired function.
How to enter the Dept Code :
1
Input a registered department code (1 to 8 digits).
2
Press the Start key.
■ Maximum Copies Limitation
After setting the maximum allowed number of copies
for each department, consult with your Key Operator
when the total copy count reaches the designated limit
and the message appears on the Touch Panel Display.
■ Auto Image Density/ Color Registration Adjustment
Function
This machine executes the following automatic
adjustment periodically. (approximately every 100
copies or print jobs) During the automatic adjustment
process, copy job/ print job will stop or jobs will be
waited approximately 60 seconds.
(1) Auto Image Density
To adjust the print density even.
(2) Color Registration Adjustment
To adjust the color registration.
■ Energy Saver (Power Save Mode, Sleep Mode)
You can set the machine to power save mode or sleep
mode while the machine is not in use. In power save
mode/sleep mode, the Energy Saver key flashes or
lights. Press the Energy Saver key to return the machine
Power Switch
to its former operating screen. For more details, refer to
(Left Side)
General Settings (Key Operator) in the Operating
Instructions (For Function Parameters) on provided CD-
ON ( )
ROM.
●
It is normal operation that the machine makes sounds
OFF ( )
when switching into power save mode.
Modes
Power Save
Mode
Sleep Mode
■ PCMCIA/PC Card Slot
PCMCIA/PC Card Connector inside the PCMCIA/PC
Card Slot is not supplied by Limited Power Sources.
Energy Saver key
Flashes: Power Save Mode
Lights : Sleep Mode
(Touch Panel Display
will be unlit)
Warm Up Time
Approx. 15 sec.
Approx. 15 sec.
11