Wash Cycle; Programme End - KitchenAid KDFX 6030 Product Sheet

WASH CYCLE

The dishwasher door must be closed and the water tap
open.
To load crockery, open the door with caution:
Beware of hot steam.
Close the door again. The programme resumes the cycle
from where it was interrupted.
The wash cycle can be interrupted at any time by
pressing RESET.

PROGRAMME END

Exercise caution when opening the door: beware of hot steam.
Only press the OFF button once the START indicator lamp has switched
off. All the indicator lamps switch off. Unload the appliance, starting from
the lower rack in order to avoid any residual drips of water falling onto
crockery below.
For even better drying results, leave the dishwasher door open a
little before unloading in order to allow the steam to dissipate,
helping the dishes to dry. The underside of the kitchen worktop
must be protected (see instructions in "Maintenance and
Installation").
Changing the programme in
progress/Resetting
- Press the START button for about 2
seconds, until the START indicator lamp
switches off.
- (Water drains for up to 60 seconds).
- The appliance is now ready to be
restarted.
Full integrated models
- Press the START/RESET button (for 2
seconds).
- Close the door.
- (Water drains for up to 60 seconds).
- The appliance is now ready to be
restarted.
12