Engine Oil; Checking & Adding Oil - Xmotos XZ 250R Owner's Manual

Using proper oil, and regularly checking, adding and changing oil will help extend the service life of your
engine. Even the best oil wears out and becomes thinner. Changing oil helps get rid of dirt and deposits in
the engine. Operating the engine with old or dirty oil may and may damage your engine. Running the
engine with not enough oil can cause serious damage to your engine.
Engine Oil Recommended: (See Also Page 71)
The chart below indicates oil for regular air temperatures. Please see the oil/air temperature chart to help
you choose the best oil for your climate.
Your motorcycle does not need oil additives. ONLY use the recommended oil. DO NOT use oil with graphite or
molybdenum additives, they may adversely affect the clutch operation. DO NOT use motor oils that display the API
circular logo that is labeled "energy conserving", they may affect the lubrication and clutch performance.
CHECKING & ADDING OIL
XZ250R - LC
Fig. 1
BASIC MAINTENANCE PROCEDURES

ENGINE OIL

SAE 10W-40
SAE 10W-50
CAUTION
1. Start and run the engine at idle for 3-5 minutes, then
stop it.
2. Wait about 2-3 minutes to allow the oil to properly
distribute itself in the engine.
3. Stand the motorcycle on a support stand so that it is not
leaning to either the right or left.
4. Remove the oil filler cap
back in to its place but DO NOT screw it back in.
5. Check that the oil level is within the (1) & (2) hash-marks
on the dip stick as in Fig. 1
6. If the oil level is at or near the upper mark (1), you do
not need to add oil.
7. If the oil level is at or near the lower mark (2), you need
to add oil.
8. Add the recommended oil until the upper mark (1), is
reached. (DO NOT OVERFILL)
9. You can also check the oil level through the sight glass
10. Repeat steps 1 through 5.
11. Reinstall the dipstick and check for any leaks.
36
, wipe it clean, and insert it