System Configuration Options - Intermatic ET90000 Series Installation And Programming Manual

holIday ConfIG(uraTIon)
Press the right key again from ZONE CONFIG to land on
HOLIDAY CONFIG where your options are:
• ADD HOLIDAY
• MODIFY HOLIDAY
• DELETE HOLIDAY
1. ADD HOLIDAY
You create a holiday when you:
• ENABLE A HOLIDAY – Establish the holiday by
choosing YES or NO.
• EDIT HOLIDAY NAME – Give the holiday a name
(up to 10 characters; default names are HOLIDAY
1, HOLIDAY 2, etc.).
• EDIT HOLIDAY DATES – Choose from FIXED or
RELATIVE holiday, where fixed is exact first and
last days of the holiday (month and day); relative for
example, is 1st day = July 4th, length = 3 days.
2. MODIFY HOLIDAY
Select the holiday you would like to enable, change/add
name, and/or edit the holiday's dates (same as above).
3. DELETE HOLIDAY
Choose any holiday(s) you would like to delete from the
zone.
eVenT ConfIG(uraTIon)
Press the right key again from HOLIDAY CONFIG to land
on EVENT CONFIG where your options are:
• ADD EVENT
• MODIFY EVENT
• DELETE EVENT
1. ADD EVENT
You add an event when you:
• ENABLE EVENT – Establish an event by choosing
YES or NO.
• EDIT EVENT NAME – Give the event a name (up
to 10 characters; default names are EVENT 1,
EVENT 2, etc.).
• EDIT EVENT TYPE – Choose whether this event
turns a circuit ON or OFF.
ET90000 Series Electronic Timer
• EDIT EVENT DATE/TIME – Input a fixed date
(month and day) or a relative date (example, 1st
day of each month); input a fixed time (hour and
minute) or an astro time (sunrise or sunset, up to
± 120 minutes allowable adjustment).
• CKT/ZONE/HOL LISTS – Select circuit(s), zone(s)
and holiday(s) for this event by placing checkmarks.
• EDIT ACTIVATION TYPE – Select activation mode,
either FIXED or PULSE. If PULSE, enter duration
in hours, minutes, and seconds.
2. MODIFY EVENT
To modify an event, first select the event to modify then
change or edit the event under ENABLE EVENT, EDIT
EVENT NAME, EDIT EVENT TYPE, EDIT EVENT DATE/
TIME, CKT/ZONE/HOL LISTS, and/or EDIT ACTIVATION
TYPE (see above).
3. DELETE EVENT
Choose the event you would like to delete.

sysTem ConfIGuraTIon opTIons

Press the right key again from EVENT CONFIG to land
on SYSTEM CONFIG. Note: From the STATUS screen,
you can also press ENTER; navigate to ADVANCED
OPTIONS, press ENTER again, then press the left key
once.
Your options are:
• REVIEW MODE
• PROG COPY/RESTORE
• PASSWORD SETUP
• EDIT SYSTEM NAME
• NETWORK SETUP
• FIRMWARE UPDATE
• RESET TO FAC DEFAULT
IMPORTANT: Use the ESC key to return to the SYSTEM
CONFIG screen after entering these options.
1. reVIeW mode
In REVIEW MODE, you can examine the parameters for
all your events by circuit and date.
14