AMC DSP 88 User Manual page 15

SOURCE: This is the channel to be copied from.
TARGET: This is the channel to be copied to.
General Settings
FREQ MODE: This changes the frequency control mode for EQ and crossover filters. It can be 36
steps/octave or All Frequencies (1 Hz resolution).
DELAY UNIT: This sets the time unit for input and output delay to ms, ft, or m.
Ethernet settings
The network settings are separated into 3 menus.
An unique IP address should be assigned to each unit in the network.
Eth-IP
Eth-GW The gateway address of the network. Usually, this should be the IP address of your
router/switch/hub address.