Table of Contents
Advertisement
KTD-405/405A User Manual
4.2.1 S
K
R
OFT
EY
EPROGRAMMING
From the supervisor programming mode you can reprogram any of the soft keys with any of the available
commands. See Appendix B. Reprogrammable Keys and Commands for a list of the keys and commands.
Note: Pressing and holding the seq key returns you to the normal operating display, except on displays where esc is required to exit.
Beginning at the normal operating display, enter the supervisor programming mode by pressing and
1)
holding the
key. Quickly move to the next step after the keypad beeps and the code entry
display appears.
CAMERA 0
MONITOR 1
Normal operating display
At the code entry display, enter the access code for the supervisor menus by pressing the 1, 4, 7, 6,
2)
and seq keys. The display will automatically advance to the next display.
ENTER PROGRAMMING
CODE:
Code entry display
!
Press the
key (for NEXT) until the PROGRAM SOFT KEYS display appears.
3)
At the PROGRAM SOFT KEYS display, press the ! side of the zoom, focus, or iris key.
4)
PROGRAM SOFT KEYS?
(+)=YES (-)=NO
PROGRAM SOFT KEYS display
At the PRESS KEY TO PROGRAM display, press any of the available reprogrammable keys (see
5)
Appendix B. Reprogrammable Keys and Commands).
PRESS KEY TO PROGRAM:
PRESS KEY TO PROGRAM display
At the command selection display, use the joystick (or the & and
6)
through the list of commands until the desired command appears. The commands are listed in
alphabetical order. Then press the
the reprogrammed soft key.
Note: Pressing the '' key returns you to the PRESS KEY TO PROGRAM display.
SLW/STOP
(())
('-)=SAVE
Command selection display
1036547C / December 2003
_
"NEXT!
ESC=EXIT
key ('─ on the display) to save the selected command for
-#
STABILIZ
''BACK
Programming
#
keys) to scroll up and down
21
Advertisement
Table of Contents
