Globecar motorhome Instruction Manual page 79

Selecting operating mode:
Winter operation
Switching on:
Switching off:
Summer operation
Motorhome - 02/11-0 - GLO-MJ11-00EN
Set the operating mode using the rotary switch (Fig. 82,3).
The power supply of the heater cannot be interrupted by means of the 12 V
main switch.
The heater selects the required burner setting according to the set heating
level. In the "Heater and boiler" operating mode (Fig. 82,6) the water in the
boiler is also heated. The heater can be operated with an empty boiler in the
"Heater without boiler" operating mode (Fig. 82,5).
Open the regulator tap on the gas bottle and the gas isolator tap "Heater/
boiler".
Set the temperature control knob (Fig. 82,1) at the operating unit to the
desired heating level.
Set the rotary switch (Fig. 82,3) to winter operation "Heater without boiler"
(Fig. 82,5) or to winter operation "Heater and boiler" (Fig. 82,6).
Green indicator lamp (Fig. 82,7) lights up.
The circulation fan automatically switches on when the heater is activated.
Set the rotary switch (Fig. 82,3) to " " (Fig. 82,4).
Close the gas isolator tap "Heater/Boiler" and the main regulator tap on the
gas bottle.
After switching off the heater, the circulation fan may still run for a moment to
use up the residual heat.
It is not possible to heat the vehicle in the "Summer" operating mode. In this
operating mode only the water in the boiler is heated.
Further information can be obtained from the separate instruction manual
"Gas heater".
For further information about the use of the boiler see Section "Boiler".
10
Appliances
79