Table of Contents
Advertisement
Control means of the JP2pro_rev.S
The following control means are recommended to perform all of the JP2pro_rev.S
functions.
(1) Front control panel option
(2) Dedicated RS-422 remote controller option, "SYNCHRO-CONT 2000"
(3) Control utility software "JP2pro-controller" for Ethernet option,
You can use commercially available editors (e.g. BVE-9100) or slow-motion controllers,
but note that most of such controllers are only adapting the VTR commands, so some
features needing the Disk Protocol are not possible.
Important notice for the Raid Configuration
You can choose the Raid-0 (striping) or the Raid-1 (mirroring) disk configuration. Note
that the actual recording capacity and the bandwidth of the hard disk drive decreases by
1/3 when using the RAID-1, so there are some cautions described below.
(1) Maximum recording time in RAID-1 configuration is 1/3 of the RAID-0.
(2) You cannot use the Lossless mode with the RAID-1.
(3) Normally, the simultaneous record/play operation is possible with the RAID-0 and
the lossy compression mode. Only the LP2 mode can use with the RAID-1.
RAID
RAID-0
RAID-1
Capability of simultaneous record/play
LOSSLESS
HQ
YES
NO
NO
NO
7
LP1
LP2
YES
YES
YES
NO
Advertisement
Table of Contents
