Using Hardware Accelerated Voice Chat - EVGA KILLER XENO PRO Installation Manual

5. Reinstall the cover on your computer and reconnect any cables that you removed earlier
in the installation.
6. Plug an Ethernet Cable into the EVGA Killer Xeno Pro. (RJ-45 port)
7. Power up your computer.
8. Insert the driver installation CD or double click on the EVGA Killer Xeno Pro driver executable file
that can be downloaded at www.evga.com/support/drivers. The setup program takes over and
will walk you through the driver installation process.
9. You may need to reboot your PC once the driver installation is complete.

Using Hardware Accelerated Voice Chat

If you are going to use the EVGA Killer Xeno Pro's built in hardware voice chat, you will need to connect
the included audio input/outputs correctly. There are two options for doing this, consisting of an internal
or external cable. NOTE: You only need to use one of the below two options.
Internal Cable:
1. Connect the four-pin audio cable to the four-pin socket near the top of the EVGA Killer Xeno Pro card.
3
2. Connect the other end of the audio cable to the input labeled "AUX" or "CD" on your motherboard
(if using onboard audio) or your soundcard if using a dedicated sound card.
3. If you do not have a four-pin audio connector available on your motherboard or sound card, follow
the directions below to connect an external cable.
External Cable:
1. Connect the external audio cable to the LINE OUT jack on the EVGA Killer Xeno Pro bracket.
2. Connect the other end of the external audio cable to the MIC IN jack on your motherboard
(if using onboard audio) or your sound card if using a dedicated sound card.
4