Dip Switch Modes - PD Technology 350 Instruction Manual

www.garagedoorsonline.co.uk

Dip Switch Modes

VOLTAGE DIPSWITCHES - LOCATED ON BACK OF UNIT
The unit is shipped out pre-set to 230 volts for operation. Under NO circumstances should
the dip switches be adjusted whilst the unit is switched on. Please contact PDT before
making any adjustment to this setting, as wrong voltage dip switch settings can seriously
affect the safety features of the shutter when used with a RollerTec control system.
FUNCTION DIPSWITCHES – LOCATED INSIDE FRONT COVER
Note: Before carrying out any dipswitch adjustments the unit should be isolated from the
mains and have its battery disconnected.
The dipswitches are located on the PCB, which is inside the front cover of the unit.
The unit will operate differently depending on the operational modes selected.
REMOVING THE COVER:
The front cover slides in the down direction towards the bottom of the unit, once it releases its
catches the cover will come away. To replace the cover press against the unit and slide up
towards the top of the unit.
Dipswitch 1 allows you to select the operating mode of the unit. By putting the dip switch in
the ON position the unit will last for around 30 days. By putting the dipswitch in the OFF
position the unit will last for around 100 days.
1 – OFF
– ON
Dip Switch 2 allows you to select how long the unit will stay awake, after any activity that
requires power or mains failure before it goes back in to standby mode. By putting the dip
switch in the OFF position the unit will stay awake for 25 seconds. By putting the dipswitch in
the ON position the unit will stay awake for 45 seconds.
2 – OFF
– ON
Dip Switch 3 allows you to select whether or not the unit is required to respond to a radio
signal transmitted by a key fob or other wireless control method.
3 – OFF
3 – ON
Dip Switch 4 allows you to select whether the unit will periodically check if mains power has
been restored or not at intervals of approximately 10 hours. It is recommended that you put
the dip switch to the ON position.
4 – OFF
4 – ON
www.garagedoorsonline.co.uk
Constant for first 24 hours then intermittent 5 - second cycle
Radio Receiver on Constant
25 Second Mode
45 Second Mode
Radio Receiver is used
Radio Receiver is disabled
No Mains Check
10-Hour Interval Checks To See If Mains Power Has Been Restored
(If mains power returns power to the load is automatically restored).
01926 463888
13
01926 463888
www.garagedoorsonline.co.uk
What Dipswitches Look like
www.garagedoorsonline.co.uk