Atwood AC-1361 Installation & Service Manual page 15

OPERATING INSTRUCTIONS FOR ADJUSTING THE THERMOSTAT (cont.)
2.
Temperature setting (continued)

To display the room temperature, press
room temperature is displayed until the key is released. Given the lack of display characters - if the control is
displaying temperature in Fahrenheit, temperatures of 100-109°F will be displayed as A0 –A9, temperatures
between 110-119°F will be displayed as B0-B9, temperatures between 120-129°F will be displayed as C0-C9,
temperatures between 130-139°F will be displayed as D0-D9, temperatures between 140-149°F
displayed as E0-E9, and temperatures between 150-159°F will be displayed as F0-F9. Temperatures are
displayed normally in degrees Centigrade.

Press
temperature set range is 16C-30C or 60F-85F.

Temperature setting is bypassed in Fan mode.
3.
Mode setting
MODE

Press
Cool→Dry→Heat→Fan→Auto Cool/Heat
Heat and Auto mode is not available for cooling only model. Auto mode is not available for model where
furnace is primary heating.

Heat LED flashes during outdoor defrost cycle
4.
Furnace setting (model 1511 only)

This function is available in heat pump + furnace model only.
FURNACE

Press
Press the same button again to disable the furnace function.
5.
Fan speed setting
FAN

Press
mode. Fan speed setting is bypass in dry mode.

When furnace is working as primary heat source in heat mode, pressing
off, display will show "FF" until button is released. Pressing
running, display will show "F0" until button is released.
6.
Sleep setting
SLEEP

Press button to activate or deactivate sleep setting. Sleep is bypass in Fan and Dry mode.
AC IOM DUCTED 12/03/2014 rev 8
FAN
and together for 5 seconds will change the temperature setting from C to F. Valid
button to change the operation mode as follow:-
button to activate furnace as primary heating. Heat pump operation will be inhibited thereafter.
button to change the fan speed：Auto→High→Medium→Low. Auto fan setting is bypass in Fan
SLEEP
button for 5sec or longer. While this button is depressed, the
MODE
.
button press is invalid during this cycle.
FAN
15
FAN
button for 5sec to turn the fan
button again for 5sec to let the fan continue
will be