Advertisement
TIMER OFF Button: Press this button to initiate the auto-off time
12
sequence. Each press will increase the auto-timed setting in 30
minutes increments. When the setting time displays 10h, each
press will increase the auto-timed setting 60 minutes increments.
To cancel the auto-timed program, simply adjust the auto-off time
to 0.0
LOCK Button: When you press the recessed LOCK button, all
13
current settings are locked in and the remote controller does not
accept any operation except that of the LOCK. Press again to
cancel the LOCK mode.
14
TURBO Button: Active/Disable Turbo function. Turbo function
enables the unit to reach the preset temperature at cooling or
heating operation in the shortest time(if the indoor unit has no
this function, there is no corresponding operation happened
when press Turbo button.)
15
LED DISPLAY Button: Press this button to clear the digit
display in the air conditioner, press it again to illuminate (Not
available for the units without LED display window).
Indicators on Display Panel
Display Panel
DIGITAL
1
DISPLAY area
TRANSMI-
2
SSION Indicator
OPERATION
4
MODE Indicator
5
LOCK Indicator
TIMER ON OFF
TIMER
6
DISPLAY Indicator
Fig. 2
DIGITAL DISPLAY area: This area will show the set temperature
1
and, if in the TIMER mode, will show the ON and OFF settings of
the TIMER. If in the FAN mode, nothing is appeared.
TRANSMISSION Indicator: This indicator flashes one time
2
when remote controller transmits signals to the indoor unit.
3
ON/OFF Indicator: This symbol appears when the unit is turned
3
on by the remote controller, and disappear when the unit is
turned off.
OPERATION MODE Indicator: When press the MODE button,
4
it shows the current operating mode -- AUTO
HEAT (Cooling only model without)
LOCK Indicator: LOCK display is displayed by pushing the
5
LOCK button. Push the LOCK button to clear display.
TIMER DISPLAY Indicator: This display area shows the settings
6
of the TIMER. That is, if only the starting time of operation is set,
it will display the TIMER ON. If only the turning off time of operation
is set, it will display the TIMER OFF. If both operations are set,
it will show TIMER ON-OFF which indicates you have chosen
to set both the starting time and off time.
7
FAN SPEED Indicator: Press the FAN SPEED button to select
the desired fan speed setting (Auto-Low-Med-High). You selection
will be displayed in the LCD window except the Auto fan speed.
NOTE: All signs shown in the Fig.2 is for the purpose of clear
presentation. But during the actual operation only the re-
lative functional signs are shown on the display panel.
Operating the Remote Controller
Install/Replace Batteries
The Remote Controller uses two alkaline dry batteries
3
ON/OFF Indicator
1. To install the batteries, slide the back cover of the battery
OPERATION
compartment and install the batteries according the
4
MODE Indicator
direction (+and -)shown on the Remote Controller.
7
2. To replace the old batteries, use the same method as
FAN SPEED Indicator
mentioned above.
NOTE
1. When replacing batteries, do not use old batteries or a different
type battery. This may cause the remote control to malfunction.
2. If you do not use the remote controller for several weeks
remove the batteries. Otherwise battery leakage may damage
the remote controller.
3. The average battery life under normal use is about 6 months.
4. Replace the batteries when there is no answering beep from the
indoor unit or if the Transmission Indicator light fails to light.
5. Do not dispose batteries as unsorted municipal waste. Collection
of such waste separately for special treatment is necessary.
COOL
DRY
mode.
(LR03X2).
4
Advertisement
