Read This Before Operation; Quick Start Guide - TaKo Electronics EBi Direct Interpolation DAC User Manual

Read this before operation

Read this before operation
-Place the unit in a stable location near the audio system that you will use. -Place the unit in a stable location near the audio system that you will use.
-As the unit may become warm during operation, always leave sufficient space around the unit for ventilation. -As the unit may become warm during operation, always leave sufficient space around the unit for ventilation.
Make sure there is at least 20 cm (8") of space above and at least 5 cm (2") of space on each side of the unit. Make sure there is at least 20 cm (8") of space above and at least 5 cm (2") of space on each side of the unit.
Do NOT place anything such as a CD, CD-R,LP, cassette tape etc. on top of the unit. Do NOT place anything such as a CD, CD-R,LP, cassette tape etc. on top of the unit.
-The voltage supplied to the unit should match the voltage as printed on the rear panel. -The voltage supplied to the unit should match the voltage as printed on the rear panel.
If you are in any doubt regarding this matter, consult an electrician. If you are in any doubt regarding this matter, consult an electrician.
-Choose the installation location of your unit carefully. Avoid placing it in direct sunlight or close to a source of heat. -Choose the installation location of your unit carefully. Avoid placing it in direct sunlight or close to a source of heat.
Also avoid locations subject to vibrations and excessive dust, heat, cold or moisture. Also avoid locations subject to vibrations and excessive dust, heat, cold or moisture.

Quick Start Guide

Quick Start Guide
1.Turn off all other audio components. 1.Turn off all other audio components.
2.Plug an IEC power cable into the IEC inlet (marked as "AC power") on the rear of the EBi. 2.Plug an IEC power cable into the IEC inlet (marked as "AC power") on the rear of the EBi.
3.connected the output from a digital source to either the coaxial,optical or USB input of the 3.connected the output from a digital source to either the coaxial,optical or USB input of the
Ebi.In the case of USB input from a PC,the PC will automatically recognize the connection and pormpt Ebi.In the case of USB input from a PC,the PC will automatically recognize the connection and pormpt
the user to accept the EBias a system audio output. the user to accept the EBias a system audio output.
4.Connect analog output of the EBi to your pre-amplifier or reciever. 4.Connect analog output of the EBi to your pre-amplifier or reciever.
5.Turn the volume of the pre-amplifier to minimum/zero and turn on your source.the pre-amplifier and 5.Turn the volume of the pre-amplifier to minimum/zero and turn on your source.the pre-amplifier and
power amplifier,and press the power button on the EBi. power amplifier,and press the power button on the EBi.
6..Ensure the pre-amplifier has the EBi selected as analog input. 6..Ensure the pre-amplifier has the EBi selected as analog input.
7.Begin playback of music on the digital source. Slowly turn the volume of the pre-amplifier up to a 7.Begin playback of music on the digital source. Slowly turn the volume of the pre-amplifier up to a
comfortable listening volume. comfortable listening volume.
8.Enjoy! 8.Enjoy!