Dvr And Keyboard Setup; Dvr Setup; Network Connection Setup - Qvis APOLLO-KEYBOARD1 User Manual

Please refer to the following figure if you are connecting via the hub. See Figure
3-5.

3.3 DVR and Keyboard Setup

3.3.1 DVR Setup

a) Before operation, please make sure cable connection is proper.
b) In DVR menu, from Setting->RS232. The COM function is network keyboard and then
set corresponding parameters.
The default setup is shown as below.

Baud rate: 9600

Data bit: 8

Stop bit: 1

Parity: none.
Please note keyboard setup should conform to DVR setup.
c) Go to the zones interface of the keyboard. Please refer to chapter 2.3.2
Note

RS232 address/RS485 address is the device No. of the DVR.

The protocol usually is DH-2. It is the network keyboard and the 2
protocol. The DVR COM protocol is network keyboard protocol.
After the setup, click 【ESC】 to exit control point control interface. System pops up a
d)
dialogue box you can click 【ENTER】 to save data or click 【ESC】 to cancel setup.

3.3.2 Network Connection Setup

The network connection steps are similar to the COM setup. Please note, on the zones interface,
the link type shall be NET.
Please input DVR IP address, the control point port is 37777. The protocol is the same as the
COM setup.
Figure 3-5
nd
control keyboard
15