Two-Outlet Receptacle Installation - Monster Power Home Theatre In-Wall PowerCenter 15 AMP Owner's Manual

HOOK-UP GUIDE - STANDALONE APPLICATIONS
Two-Outlet Receptacle Installation
Monster In-Wall PowerCenters are available with either 15-amp or 20-amp outlet. Be sure to use the outlet that
matches your existing branch circuit.
A) Connect the output wires extending from the Surge Module to the two-outlet receptacle as follows:
1. Remove the three screws from the side of the two-outlet receptacle by turning
each counterclockwise until loose.
2.
Connect the solid copper wires from the Surge Module to the corresponding line, neutral,
and ground terminals on the
Out~t
Receptacle.
3.
Re-tighten each screw
by
turning dockwise until snug.
B) Attach the included gold-plated grounding plate and both the two-outlet receptacle and the Surge Module
to the two gang outlet box by tucking any excess wire away, aligning the holes between the gold-plated
grounding plate, the two units, and the two gang outlet box, inserting 4 included silver screws (2 each unit),
and turning each clockwise until secure.
Surge Module Two-Outlet
Receptacle