Gas Input Rate Adjustment - Slant/Fin VSPH-60 Operating Instructions Manual

Victory vsph series direct-vent sealed combustion boilers hot water models

Hide thumbs Also See for VSPH-60:

Installation and operating instructions manual (28 pages)

Table of Contents

II. Initial Start

Safe lighting and other performance criteria were met when

testing various gas manifold and control assemblies used

on the Victory VSPH Series Boilers under the ANSI Z21.13-

latest edition or CSA B149.1-00 for natural gas and

propane.

Instructions

Follow the lighting instructions in this manual. These

instructions are also attached to the boiler.

SAFETY INFORMATION

For Your Safety Read Before Operating

WARNING: If you do not follow these instructions

exactly, a fire or explosion may result causing proper-

ty damage, personal injury or loss of life.

A. This appliance is equipped with an ignition device which

automatically lights the pilot. DO NOT try to light the pilot

by hand.

B. BEFORE OPERATING smell all around the appliance area

for gas. Be sure to smell next to the floor because some

gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS:

• DO NOT try to light any appliance.

• DO NOT touch any electric switch: DO NOT use any

phone in your building.

• Immediately call you gas supplier from a neighbor's

phone. Follow the gas supplier's instructions.

• If you cannot reach your gas supplier, call the fire depart-

ment.

C.Use only your hand to turn the gas control knob. Never use

tools. If the knob will not turn by hand, don't try to repair it,

call a qualified service technician. Force or attempted repair

may result in a fire or explosion.

D. Do Not use this appliance if any part has been under water.

Immediately call a qualified service technician to inspect the

appliance and to replace any part of the control system and

any gas control which has been under water.

OPERATING INSTRUCTIONS

1. STOP! Read the safety information above.

2. Set the thermostat to lowest setting.

3. Turn off all electric power to the appliance.

4. This appliance is equipped with an ignition device which

automatically lights the pilot. DO NOT try to light the pilot

by hand.

5. Remove jacket front panel

6. Turn gas control knob clockwise

DO NOT force.

7. Wait five (5) minutes (longer for propane) to clear out any

gas, then smell for gas, including near the floor. If you

then smell gas, STOP! Follow "B" in the safety information

above on this page. If you don't smell gas, go to next

step.

8. Turn as control knob counterclockwise

9. Replace jacket front panel.

10. Turn on all electric power to the appliance.

11. Set thermostat to desired setting.

12. If the appliance will not operate, follow the instructions "To

Turn Off Gas to Appliance" and call your service technician

or gas supplier.

1. Set thermostat to lowest setting.

2. Turn off all electric power to the appliance if service is to

3. Remove jacket front panel.

4. Turn gas control knob clockwise

5. Replace jacket front panel.

Removing Jacket Front Panel

1. Turn black screws

2. Remove front panel.

1. Consult gas supplier for higher heating value* of gas

2. Set thermostat high enough so that boiler will remain on

3. Measure manifold pressure.

to "OFF".

* "Higher Heating" value of gas is commonly known as "heating value".

to "ON".

To Turn Off Gas to Appliance

be performed.

then continue to "OFF". Do not force.

turn to open position.

To replace the panel, reverse procedure.