Add Source Only Dvb-S; Positioner 1.2 Only Dvb-S - Elium Elipsus CI 230 S YUV Operating Instructions Manual

4.2.2 Add Source
Option: Main Menu / Configuration / Installation / add Source.
Here you can add manual new satellites which are currently not
integrated in the Elipsus firmware.
▪ Enter the name and the position of the satellite you want to add by pressing
the Numeric button (2) of Remote Control.
▪ Select the position of the new satellite using the Plus/Minus button (8) for
the West (W) and the East (E) postition.
▪ To move between the input windows press the Up and Down button (7).
▪ To save the settings press the OK button (10).
▪ The parameter of the new satellite are saved now and you can start with
the installation of the antenna which is described in Section 3.2 and with
the channel search like described in Section 3.3.1.
4.2.3 Positioner 1.2
Option: Main Menu / Configuration / Installation / Positioner.
Here you can set up your positioner.
Before set up you have to check if the positioner is activated in
the antenna installation.
▪ Select the satellite you want to receive using
the Plus/Minus button (8).
▪ With the Numeric button 1 and 3 you can
move the postioner to West and to East. An
acoustic sound and the signal indicated helps
you to find the correct position.
▪ When the signal is correct indicated you have
to stop the positioner by pressing the Nume-
ric button 2.
▪ With the Numeric button 4 and 6 you can
addtional start the fine tuning.
▪ The correct position of the satellite you can save by pressing the Numeric
button 8.
▪ To calculate the position of an other satellite based on the current position
you have to press the Numeric button 7.
▪ To move the positioner to the zeropoint as reference position you have to
press the Numeric button 9.
▪ To save the set up you have to press the Menu button (11).
Menu
34