Table of Contents
Advertisement
Installation
3.4 Antenna Setting DVB-S
After setting the Audio Settings you have to set up the Antenna. Depending on the receiption option of the
unit you have different options are shown for the channelsearch.
The Signum is programmed for Astra Satellite but you can set up the antenna installtion as well as the
channel search for other satellites.
▪ To move between the different options you have to press the Up or Down button (7).
▪ To select one setting you have to press the Plus or Minus button (8).
▪ If you use only one LNB you have to select at the option LNB Connection: Direct.
Otherwise if you use several LNB or several Antenna connected to a Multiswitch you have to assign to each
seperate LNB or Antenna an own DiSEqC connection.
For the correct set up you have to adjust the following parameter.
▪ Select the satellite you want to receive.
▪ Select the LNB Number for example: Antenna 1 correspond to LNB Number 1, Antenna 2 correspond to
LNB Number 2 .....
▪ Select the DiSEqC for example DiSEqC A correspond to Sat System A, DiSEqC correspond to Sat
System B .....
▪ Press the Exit button (9) to save the parameter.
Example:
Hotbird - LNB number 2 - LNB connection DiSEqC B and Astra - LNB number 1 - LNB
connection DiSEqC A. After correct set up you will see after some seconds the signal
quality shown at the OSD.
20
Advertisement
Table of Contents
