Advertisement
INSTALLATION
Join the inverter connector & apply power
step 4
> After installation is complete, join the inverter connector and apply AC power.
> At this point, power should be connected to both the AC ballast and the backup micro inverter, and the
Charging Indicator Light should illuminate indicating the battery is charging.
> A short-term discharge test may be conducted after the backup micro inverter has been charging for 1 hour.
Charge for 24 hours before conducting a long-term discharge test. refer to operation.
illustration 1
3
The T-BAR mounting bracket assembly is sold separately and is available from the factory as an accessory kit (T-BAR-MB).
†
Call your local distributor or the factory for complete information.
1
– Flexible conduit (supplied) to connect ballast wires.
2
– Existing conduit to run existing wires to lamp holder.
3
– AC line in.
4
– Conduit and junction box (not supplied).
TEST/MONITOR
4
4
Backup Micro Inverter
PLATE
BRACKET
2
1
No Shading – Equipment supplied by others
3
T-BAR
†
Advertisement
